Document Server@UHasselt >
Research >
Research publications >

Please use this identifier to cite or link to this item: http://hdl.handle.net/1942/7813

Title: Electrostatic force microscopy studies of boron-doped diamond films
Authors: Gupta, S.
Bohannan, E.
Issue Date: 2007
Citation: JOURNAL OF MATERIALS RESEARCH, 22(11). p. 3014-3028
Abstract: Much has been learned from electrochemical properties of boron-doped diamond (BDD) thin films synthesized using microwave plasma-assisted chemical vapor deposition about the factors influencing electrochemical activity, but some characteristics are still not entirely understood, such as its electrical conductivity in relation with microscale structure. Therefore, to effectively utilize these materials, understanding both the microscopic structure and physical (electrical, in particular) properties becomes indispensable. In addition to topography using atomic force microscopy, electrostatic force microscopy (EFM) in phase mode measuring the long-range electrostatic force gradients, helps to map the electrical conductivity heterogeneity of boron-doped micro-/nanocrystalline diamond surfaces. The mapping of electrical conductivity on boron doping and bias voltage is investigated. Experimental results showed that the BDD films' surfaces were partially rougher with contrast of conductive regions (areas much less than 1 mu m(2) in diameter), which were uniformly distributed. Usually, the EFM signal is a convolution of topography and electrostatic force, and the phase contrast was increased with boron doping. At the highest boron doping level, the conductive regions exhibited quasi-metallic electrical properties. Moreover, the presence of a "positive-negative-positive" phase shift along the line section indicates the presence of "insulating-conducting-insulating" phases, although qualitative. Furthermore, the electrical properties, such as capacitance and dielectric constants at operating frequency, were quantitatively evaluated through modeling the bias-dependent phase measurements using simple and approximate geometries. It was found that decreasing grain size (or increasing the boron concentration) lowers the dielectric constant, which is attributed to the change in the crystal field caused by surface bond contraction of the nanosized crystallites. These findings are complemented and validated with scanning electron microscopy, x-ray diffraction, and "visible" Raman spectroscopy revealing their morphology, structure, and carbon-bonding configuration (sp(3) versus sp(2)), respectively. These results are significant in the development of electrochemical nano-/microelectrodes and diamond-based electronics.
Notes: Univ Missouri, Dept Elect & Comp Engn, Columbia, MO 65211 USA. Univ Hasselt, Mat Res Inst, BE-3590 Diepenbeek, Belgium. Univ Missouri, Dept Chem, Rolla, MO 65409 USA.Gupta, S, Univ Missouri, Dept Elect & Comp Engn, Columbia, MO 65211 USA.guptas@missouri.edu
URI: http://hdl.handle.net/1942/7813
DOI: 10.1557/JMR.2007.0229
ISI #: 000250768700007
ISSN: 0884-2914
Category: A1
Type: Journal Contribution
Validation: ecoom, 2008
Appears in Collections: Research publications

Files in This Item:

There are no files associated with this item.

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.